Products > Residential > Water Heating > Nyletherm-1 Heat Pump Water Heater


INTRODUCING THE MOT EFFICIENT AIR SOURCE HEAT PUMP EVER MADE


Nyletherm-1 Heat Pump Water Heater

The Nyletherm 1 Heat Pump Hot Water heater has already been proven in thousands of installations. Independent tests have shown that electric hot water heating bills are reduced by an average of 50%.

Savings are much greater than with instantaneous or tankless hot water heaters.

The Nyletherm 1 is used with any standard electric hot water heater holding over 30 gallons. It can be used with gas hot water heaters or plain tanks but the ETL label applies only to installations using electric hot water heaters. Contact Nyle if you wish to adapt the Nyletherm 1 to another type of tank other than an electric hot water heater.

There is no separate power supply required for the Nyletherm 1. It is attached to the tank using a wiring kit supplied with the system.

The Nyletherm 1 features an oversized cooling coil and variable speed fan to improve efficiency and prevent coil freeze-up. The speed control minimizes the already quiet sound level.

The Nyletherm 1 is a great dehumidifier. It cools and dehumidifies the air in the space where it is located. Many find they can stop using a separate dehumidifier and still keep the basement dry.

Some people install their Nyletherm 1 in the occupied space to take advantage of a wood stove and use the cooling in the summer. When cooling is not needed, the air can be directed outside. Nyle offers a duct adapter option

In the South, many place a Nyletherm 1 in a garage or other area that can make use of the cooling and dehumidification while heating water.

There is normally no special piping required. The Nyletherm 1 comes with a complete tubing and valve kit. The drain valve is removed from the tank and a special arrangement with a tube-in-tube is supplied that allows circulation through the single drain opening is supplied for quick and easy installation. Some tanks with a plastic liner will require some minor plumbing.

A wall hanger kit is provided at no additional charge. The Nyletherm 1 can be hung on the wall or placed on the floor next to the hot water heater.

A condensate pump is available for locations where gravity drains cannot be used.


 

 

SPECIFICATIONS:
Output - 8000 BTU
Recovery - 15 gallons per hour at 120ºF
tank temperature
Maximum Water Temp - 140ºF

FEATURES:- Highly efficient, safe and reliable
- Fail-safe design to
ensure hot water at all times
- Engineered for flexible and easy
installation

ELECTRICAL:
Volts: 208/220
Amps:  5

Phase:  1
Frequency:  60Hz

DIMENSIONS:
10.5" Wide
15.5" Deep

26" High

- Can be wall mounted
- Virtually maintenance free -Dehumidifies at a rate of 1 quart per operating hour
- Thousands sold nationwide
- 2 year limited warranty

Optional Accessories
• 220v condensate pump (optional)
• Duct kit (optional)
• Wall Mount bracket
• 20 foot power cord for remote installations
• 20 water tubes for remote installations sediment

 



© 2002 Nyle Special Products, LLC. All rights reserved.

 

 


Nyle Special Products

P.O. Box 1107
Bangor, ME 04402

P 207.942.2865
F 207.942.2859
E info@nyletherm.com

 

spacespace spacespacespace